HOW TO INSTALL VINYL LETTERS or DECALS:
MATERIALS:
Squeege or similar flat object.
Spray bottle filled with mix (1 liter of water +
4 drops of liquid soap)
Paper towel.
Masking tape.
1. Be sure to clean the surface you wish to apply the
lettering to.
2.Position the lettering on the surface so you have an idea
of what it will look like.Measure and make sure the lettering
is straight and in the right place.
Check twice! Or even three times.
3.Place masking tape only on the top of the lettering, so
you have way to lift the letters off the surface without
losing their position.
4.Flip and peel back the paper backing off slowly,
making sure the vinyl letters are sticking to the
application tape.
5.Spray the surface with the solution mix.Also spray
the decal (sticky side)
6.Now flip down and press the decal onto the
surface begining at the top and working down.
7.The decal should be firmely press against the
surface, for this purpose use a squeege but if
you don't have a squeege, a credit card or
similar flat object can be used.Start at the center
and work outwards using firm strokes.
8. After all the bubbles have been removed, it is
time to remove the pre-mask and reveal your
lettering.To make it easier, you may spray the
paper with the mixture of water and soap.Wait a
minute or two until the pre-mask becomes soggy
and then gently pull the pre-mask off.Be carefull
during removal to prevent the decal lifting from
the surface.
9.If any bubbles still exist squeege the bubbles
toward the edges.For large bubbles you may
need to use a pin to prick the bubble before
using the squeege.


ENJOY! YOU DID IT! WAY TO GO!
banners,vinyl banners,custom banners,signs,full color baner,las vegas